Automotive Electromagnetic Compatibility (EMC) Standards

Source: Clemson Vehecular Electronics Laboratory (CVEL)

CISPR (Automotive Emissions Requirements)

Document Number	Title
CISPR 12	Vehicles, boats, and internal combustion engine driven devices – Radio disturbance characteristics – Limits and methods of measurement for the protection of receivers except those installed in the vehicle/boat/device itself or in adjacent vehicles/boats/devices
CISPR 25	Radio disturbance characteristics for the protection of receivers used on board vehicles, boats, and on devices – Limits and methods of measurement

ISO (Automotive Immunity Requirements)

Document Number	Title
ISO 7637-1	Road vehicles — Electrical disturbances from conduction and coupling — Part 1: Definitions and general considerations
ISO 7637-2	Road vehicles — Electrical disturbances from conduction and coupling — Part 2: Electrical transient conduction along supply lines only
ISO 7637-3	Road vehicles — Electrical disturbance by conduction and coupling — Part 3: Vehicles with nominal 12 V or 24 V supply voltage — Electrical transient transmission by capacitive and inductive coupling via lines other than supply lines
ISO/TR 10305-1	Road vehicles — Calibration of electromagnetic field strength measuring devices — Part 1: Devices for measurement of electromagnetic fields at frequencies > 0 Hz
ISO/TR 10305-2	Road vehicles — Calibration of electromagnetic field strength measuring devices — Part 2: IEEE standard for calibration of electromagnetic field sensors and probes, excluding antennas, from 9 kHz to 40 GHz
ISO 10605	Road vehicles — Test methods for electrical disturbances from electrostatic discharge
ISO/TS 14907-1	Road transport and traffic telematics — Electronic fee collection — Test procedures for user and fixed equipment — Part 1: Description of test procedures
ISO/TS 14907-2	Road transport and traffic telematics — Electronic fee collection — Test procedures for user and fixed equipment — Part 2: Conformance test for the onboard unit application interface
ISO/TS 21609	Road vehicles — (EMC) guidelines for installation of aftermarket radio frequency transmitting equipment
ISO 11451-1	Road vehicles — Vehicle test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 1: General principles and terminology
ISO 11451-2	Road vehicles — Vehicle test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 2: Off-vehicle radiation sources
ISO 11451-3	Road vehicles — Electrical disturbances by narrowband radiated electromagnetic energy — Vehicle test methods — Part 3: On-board transmitter simulation
ISO 11451-4	Road vehicles — Vehicle test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 4: Bulk current injection (BCI)
ISO 11452-1	Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 1: General principles and terminology
ISO 11452-2	Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 2: Absorber-lined shielded enclosure
ISO 11452-3	Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 3: Transverse electromagnetic mode (TEM) cell
ISO 11452-4	Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 4: Bulk current injection (BCI)
ISO 11452-5	Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 5: Stripline
ISO 11452-7	Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 7: Direct radio frequency (RF) power injection
ISO 11452-8	Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 8: Immunity to magnetic fields
ISO 11452-10	Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 10: Immunity to conducted disturbances in the extended audio frequency range
ISO 11452-11	Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 11: Reverberation chamber
ISO 13766	Earth-moving machinery — Electromagnetic compatibility

SAE (Automotive Emissions and Immunity)

Document Number	Title
J1113/1	Electromagnetic Compatibility Measurement Procedures and Limits for Components of Vehicles, Boats (Up to 15 M), and Machines (Except Aircraft) (50 Hz to 18 Ghz)
J1113/2	Electromagnetic Compatibility Measurement Procedures and Limits for Vehicle Components (Except Aircraft)–Conducted Immunity, 15 Hz to 250 kHz–All Leads
J1113/3	Conducted Immunity, 250 kHz to 400 MHz, Direct Injection of Radio Frequency (RF) Power
J1113/4	Immunity to Radiated Electromagnetic Fields-Bulk Current Injection (BCI) Method
J1113/11	Immunity to Conducted Transients on Power Leads
J1113/12	Electrical Interference by Conduction and Coupling – Capacitive and Inductive Coupling via Lines Other than Supply Lines
J1113/13	Electromagnetic Compatibility Measurement Procedure for Vehicle Components – Part 13: Immunity to Electrostatic Discharge
J1113/21	Electromagnetic Compatibility Measurement Procedure for Vehicle Components – Part 21: Immunity to Electromagnetic Fields, 30 MHz to 18 GHz, Absorber-Lined Chamber
J1113/24	Immunity to Radiated Electromagnetic Fields; 10 kHz to 200 MHz–Crawford TEM Cell and 10 kHz to 5 GHz–Wideband TEM Cell
J1113/26	Electromagnetic Compatibility Measurement Procedure for Vehicle Components – Immunity to AC Power Line Electric Fields
J1113/27	Electromagnetic Compatibility Measurements Procedure for Vehicle Components – Part 27: Immunity to Radiated Electromagnetic Fields – Mode Stir Reverberation Method
J1113/28	Electromagnetic Compatibility Measurements Procedure for Vehicle Components–Part 28–Immunity to Radiated Electromagnetic Fields–Reverberation Method (Mode Tuning)
J1113/42	Electromagnetic Compatibility–Component Test Procedure–Part 42–Conducted Transient Emissions
J1752/1	Electromagnetic Compatibility Measurement Procedures for Integrated Circuits-Integrated Circuit EMC Measurement Procedures-General and Definition
J1752/2	Measurement of Radiated Emissions from Integrated Circuits — Surface Scan Method (Loop Probe Method) 10 MHz to 3 GHz
J1752/3	Measurement of Radiated Emissions from Integrated Circuits — TEM/Wideband TEM (GTEM) Cell Method; TEM Cell (150 kHz to 1 GHz), Wideband TEM Cell (150 kHz to 8 GHz)
J551/5	Performance Levels and Methods of Measurement of Magnetic and Electric Field Strength from Electric Vehicles, Broadband, 9 kHz To 30 MHz
J551/11	Vehicle Electromagnetic Immunity–Off-Vehicle Source
J551/12	Vehicle Electromagnetic Immunity–On-Board Transmitter Simulation
J551/13	Vehicle Electromagnetic Immunity–Bulk Current Injection
J551/15	Vehicle Electromagnetic Immunity–Electrostatic Discharge (ESD)
J551/16	Electromagnetic Immunity – Off-Vehicle Source (Reverberation Chamber Method) – Part 16 – Immunity to Radiated Electromagnetic Fields
J551/17	Vehicle Electromagnetic Immunity — Power Line Magnetic Fields
J1812	Function Performance Status Classification for EMC Immunity Testing
J2628	Characterization–Conducted Immunity
J2556	Radiated Emissions (RE) Narrowband Data Analysis–Power Spectral Density (PSD)

GM

Document Number	Title
GMW3091	General Specification for Vehicles, Electromagnetic Compatibility (EMC)-Engl; Revision H; Supersedes GMI 12559 R and GMI 12559 V
GMW3097	General Specification for Electrical/Electronic Components and Subsystems, Electromagnetic Compatibility-Engl; Revision H; Supersedes GMW12559, GMW3100, GMW12002R AND GMW12002V
GMW3103	General Specification for Electrical/Electronic Components and Subsystems, Electromagnetic Compatibility Global EMC Component/Subsystem Validation Acceptance Process-Engl; Revision F; Contains Color; Replaces GMW12003, GMW12004 and GMW3106

Ford

Document Number	Title
EMC-CS-2009.1	Component EMC Specification EMC-CS-2009.1
FORD F-2	Electrical and Electronics System Engineering
FORD WSF-M22P5-A1	Printed Circuit Boards, PTF, Double Sided, Flexible

Chrysler

Document Number	Title
DC-10615	Electrical System Performance Requirements for Electrical and Electronic Components
DC-11224	EMC Performance Requirements — Components
DC-11225	EMC Supplemental Information and Alternative Component Requirements
DC-11223	EMC Performance Requirements — Vehicle

Other Automotive Manufacturers

Audi TL 82466	Electrostatic Discharge
BMW 600 13.0	Electric- / Electronic components in cars
BMW GS 95002	Electromagnetic Compatibility (EMC) Requirements and Tests
BMW GS 95003-2	Electric- / Electronic assemblies in motor vehicles
Chrysler PF 9326	Electrical electronic modules and motors
FIAT 9.90110	Electric and electronic devices for motor vehicles
Freightliner 49-00085	EMC requirements
Honda 3838Z-S5AA-L000	Noise Simulation Test
Honda 3982Z-SDA-0030
Hyundai ES 39110-00	EMC requirements
Hyundai ES 96100-01
IVECO 16-2103	EMC requirements
Kia/Hyundai ES-95400-10
Lotus 17.39.01	Lotus Engineering Standard: Electromagnetic Compatibility
Mack Trucks 606GS15	EMC requirements
MAN 3285	EMC requirements
Mazda MES PW 67600	Automobile parts standard (electronic devices)
Mercedes A 211 000 42 99	Instruction specification of test method for E/E-components
Mercedes AV EMV	Electric aggregate and electronics in cars
Mercedes MBN 10284-2	EMC requirements and tests of E/E-systems (component test procedures)
Mercedes MBN 22100-2	Electric / electronic elements, devices in trucks
Mitsubishi ES-X82010	General specification of environment tests on automotive electronic equipment
Nissan 28400 NDS03	Low frequency surge resistance of electronic parts
Nissan 28400 NDS07	Immunity against low frequency surge (induction surge) of electronic parts
Nissan 28401 NDS02	EMC requirements (instruction concerning vehicle and electrical…)
Porsche AV EMC EN	EMC requirements
PSA B21 7090	EMC requirements (electric and electronics equipment)
PSA B21 7110	EMC requirements (electric and electronics equipment)
Renault 36.00.400	Physical environment of electrical and electronic equipments
Renault 36.00.808	EMC requirements (cars and electrical / electronic components)
Scania TB1400	EMC requirements
Scania TB1700
Smart DE10005B	EMC requirements (electric aggregate and electronics in cars)
Toyota TSC7001G	Engineering standard (electric noise of electronic devices)
Toyota TSC7001G-5.1	Power Supply Voltage Characteristic Test
Toyota TSC7001G-5.2	Field Decay Test
Toyota TSC7001G-5.3	Floating Ground Test
Toyota TSC7001G-5.4	Induction Noise Resistance
Toyota TSC7001G-5.5.3	Load Dump Test-1
Toyota TSC7001G-5.5.4	Load Dump Test-2
Toyota TSC7001G-5.5.5	Load Dump Test-3
Toyota TSC7001G-5.6	Over Voltage Test
Toyota TSC7001G-5.7.3	Ignition Pulse (Battery Waveforms) Test-1
Toyota TSC7001G-5.7.4	Ignition Pulse (Battery Waveforms) Test-2
Toyota TSC7001G-5.8	Reverse Voltage
Toyota TSC7006G-4.4.2	Wide Band-Width Antenna Nearby Test (0.4 to 2 GHz)
Toyota TSC7006G-4.4.3	Radio Equipment Antenna nearby Test (28 MHz …)
Toyota TSC7006G-4.4.4	Mobile Phone Antenna Nearby Test (835 MHz…)
Toyota TSC7018G	Static Electricity Test
Toyota TSC7025G-5	TEM Cell Test (1 to 400 MHz)
Toyota TSC7025G-6	Free Field Immunity Test (20 MHz to 1 GHz AM, 0.8 to 2 GHz PM)
Toyota TSC7025G-7	Strip Line Test (20 – 400 MHz)
Toyota TSC7026G-3.4	Narrow Band Emissions
Toyota TSC7203G	Voltage Drop / Micro Drops
Toyota TSC7508G-3.3.1	Conductive Noise in FM and TV Bands
Toyota TSC7508G-3.3.2	Conductive noise in LW, AM and SW Bands
Toyota TSC7508G-3.3.3	Radiated Noise in FM and TV Bands
Toyota TSC7508G-3.3.4	Radiated Noise in AM, SW, and LW Bands
Toyota TSC7203G	Engineering standard (ABS-TRC computers)
Toyota TXC7315G	Electrostatic Discharge (Gap Method)
Visteon ES-XU3F-1316-AA
Volvo EMC Requirements	EMC requirements for 12V and 24V systems
Volkswagen VW TL 801 01	Electric and electronic components in cars
Volkswagen VW TL 820 66	Conducted Interference
Volkswagen VW TL 821 66	EMC requirements of electronic components – bulk current injection (BCI)
Volkswagen VW TL 823 66	Coupled Interference on Sensor Cables
Volkswagen VW TL 824 66	Immunity Against Electrostatic Discharge
Volkswagen VW TL 965	Short-Distance Interference Suppression