Automotive Electromagnetic Compatibility (EMC) Standards

Source: Clemson Vehecular Electronics Laboratory (CVEL)

Automotive Electromagnetic Compatibility (EMC) Standards

CISPR (Automotive Emissions Requirements)

Document
Number

Title


CISPR 12

 Vehicles, boats, and internal combustion engine driven devices – Radio disturbance characteristics – Limits and methods of measurement for the protection of receivers except those installed in the vehicle/boat/device itself or in adjacent vehicles/boats/devices


CISPR 25

 Radio disturbance characteristics for the protection of receivers used on board vehicles, boats, and on devices – Limits and methods of measurement

ISO (Automotive Immunity Requirements)

Document
Number

Title


ISO 7637-1

 Road vehicles — Electrical disturbances from conduction and coupling — Part 1: Definitions and general considerations


ISO 7637-2

 Road vehicles — Electrical disturbances from conduction and coupling — Part 2:
Electrical transient conduction along supply lines only


ISO 7637-3

 Road vehicles — Electrical disturbance by conduction and coupling — Part 3: Vehicles with nominal 12 V or 24 V supply voltage — Electrical transient
transmission by capacitive and inductive coupling via lines other than supply lines


ISO/TR 10305-1

 Road vehicles — Calibration of electromagnetic field strength measuring devices — Part 1: Devices for measurement of
electromagnetic fields at frequencies > 0 Hz


ISO/TR 10305-2

 Road vehicles — Calibration of electromagnetic field strength measuring devices — Part 2: IEEE standard for calibration of
electromagnetic field sensors and probes, excluding antennas, from 9 kHz to 40 GHz

ISO 10605

 Road vehicles — Test methods for electrical disturbances from electrostatic discharge


ISO/TS 14907-1

 Road transport and traffic telematics — Electronic fee collection — Test procedures for user and fixed equipment — Part 1: Description of test procedures


ISO/TS 14907-2

 Road transport and traffic telematics — Electronic fee collection — Test procedures for user and fixed equipment — Part 2: Conformance test for the onboard unit application interface


ISO/TS 21609

Road vehicles — (EMC) guidelines for installation of aftermarket radio frequency transmitting equipment

ISO 11451-1

Road vehicles — Vehicle test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 1: General principles and terminology


ISO 11451-2

 Road vehicles — Vehicle test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 2: Off-vehicle radiation sources


ISO 11451-3

 Road vehicles — Electrical disturbances by narrowband radiated electromagnetic energy — Vehicle test methods — Part 3: On-board transmitter simulation


ISO 11451-4

 Road vehicles — Vehicle test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 4: Bulk current injection (BCI)


ISO 11452-1

 Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 1: General principles and terminology


ISO 11452-2

 Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 2: Absorber-lined shielded enclosure


ISO 11452-3

 Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 3: Transverse electromagnetic mode (TEM) cell


ISO 11452-4

 Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 4: Bulk current injection (BCI)


ISO 11452-5

 Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 5: Stripline


ISO 11452-7

 Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 7: Direct radio frequency (RF) power injection


ISO 11452-8

 Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 8: Immunity to magnetic fields

ISO 11452-10

 Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 10: Immunity to conducted disturbances in the extended audio frequency range

ISO 11452-11

 Road vehicles — Component test methods for electrical disturbances from narrowband radiated electromagnetic energy — Part 11: Reverberation chamber


ISO 13766

 Earth-moving machinery — Electromagnetic compatibility

SAE (Automotive Emissions and Immunity)

Document Number

Title


J1113/1

 Electromagnetic Compatibility Measurement Procedures and Limits for Components of Vehicles, Boats (Up to 15 M), and Machines (Except Aircraft) (50 Hz to 18 Ghz)


J1113/2

 Electromagnetic Compatibility Measurement Procedures and Limits for Vehicle Components (Except Aircraft)–Conducted Immunity, 15 Hz to 250 kHz–All Leads


J1113/3

 Conducted Immunity, 250 kHz to 400 MHz, Direct Injection of Radio Frequency (RF) Power


J1113/4

 Immunity to Radiated Electromagnetic Fields-Bulk Current Injection (BCI) Method


J1113/11

 Immunity to Conducted Transients on Power Leads


J1113/12

 Electrical Interference by Conduction and Coupling –  Capacitive and Inductive Coupling via Lines Other than Supply Lines


J1113/13

 Electromagnetic Compatibility Measurement Procedure for Vehicle Components – Part 13: Immunity to Electrostatic Discharge


J1113/21

 Electromagnetic Compatibility Measurement Procedure for Vehicle Components – Part 21: Immunity to Electromagnetic Fields, 30 MHz to 18 GHz, Absorber-Lined Chamber

J1113/24

  Immunity to Radiated Electromagnetic Fields; 10 kHz to 200 MHz–Crawford TEM Cell and 10 kHz to 5 GHz–Wideband TEM Cell


J1113/26

 Electromagnetic Compatibility Measurement Procedure for Vehicle Components – Immunity to AC Power Line Electric Fields


J1113/27

 Electromagnetic Compatibility Measurements Procedure for Vehicle Components – Part 27: Immunity to Radiated Electromagnetic Fields – Mode Stir Reverberation Method


J1113/28

 Electromagnetic Compatibility Measurements Procedure for Vehicle Components–Part 28–Immunity to Radiated Electromagnetic Fields–Reverberation Method (Mode Tuning)


J1113/42

 Electromagnetic Compatibility–Component Test Procedure–Part 42–Conducted Transient Emissions


J1752/1

 Electromagnetic Compatibility Measurement Procedures for Integrated Circuits-Integrated Circuit EMC Measurement Procedures-General and Definition


J1752/2

 Measurement of Radiated Emissions from Integrated Circuits — Surface Scan Method (Loop Probe Method) 10 MHz to 3 GHz


J1752/3

 Measurement of Radiated Emissions from Integrated Circuits — TEM/Wideband TEM (GTEM) Cell Method; TEM Cell (150 kHz to 1 GHz), Wideband TEM Cell (150 kHz to 8 GHz)


J551/5

 Performance Levels and Methods of Measurement of Magnetic and Electric Field Strength from Electric Vehicles, Broadband, 9 kHz To 30 MHz


J551/11

 Vehicle Electromagnetic Immunity–Off-Vehicle Source


J551/12

 Vehicle Electromagnetic Immunity–On-Board Transmitter Simulation


J551/13

 Vehicle Electromagnetic Immunity–Bulk Current Injection


J551/15

 Vehicle Electromagnetic Immunity–Electrostatic Discharge (ESD)


J551/16

 Electromagnetic Immunity – Off-Vehicle Source (Reverberation Chamber Method) – Part 16 – Immunity to Radiated Electromagnetic Fields


J551/17

 Vehicle Electromagnetic Immunity — Power Line Magnetic Fields


J1812

 Function Performance Status Classification for EMC Immunity Testing


J2628

 Characterization–Conducted Immunity


J2556

 Radiated Emissions (RE) Narrowband Data Analysis–Power Spectral Density (PSD)

GM

Document
Number

Title

GMW3091

 General Specification for Vehicles, Electromagnetic Compatibility (EMC)-Engl; Revision H; Supersedes GMI 12559 R and GMI 12559 V


GMW3097

 General Specification for Electrical/Electronic Components and Subsystems, Electromagnetic Compatibility-Engl; Revision H; Supersedes GMW12559, GMW3100, GMW12002R AND GMW12002V


GMW3103

 General Specification for Electrical/Electronic Components and Subsystems, Electromagnetic Compatibility Global EMC Component/Subsystem Validation Acceptance Process-Engl; Revision F; Contains Color; Replaces GMW12003, GMW12004 and GMW3106

Ford

Document
Number

Title


EMC-CS-2009.1

 Component EMC Specification EMC-CS-2009.1


FORD F-2

 Electrical and Electronics System Engineering


FORD WSF-M22P5-A1

 Printed Circuit Boards, PTF, Double Sided, Flexible

Chrysler

Document
Number

Title

DC-10615

 Electrical System Performance Requirements for Electrical and Electronic Components

DC-11224

 EMC Performance Requirements — Components

DC-11225

 EMC Supplemental Information and Alternative Component Requirements

DC-11223

EMC Performance Requirements — Vehicle

Other Automotive Manufacturers

  Audi TL 82466   Electrostatic Discharge
  BMW 600 13.0   Electric- / Electronic components in cars
  BMW GS 95002   Electromagnetic Compatibility (EMC) Requirements and Tests
  BMW GS 95003-2   Electric- / Electronic assemblies in motor vehicles
  Chrysler PF 9326   Electrical electronic modules and motors
  FIAT 9.90110   Electric and electronic devices for motor vehicles
  Freightliner 49-00085   EMC requirements
  Honda 3838Z-S5AA-L000   Noise Simulation Test
  Honda 3982Z-SDA-0030
  Hyundai ES 39110-00   EMC requirements
  Hyundai ES 96100-01
  IVECO 16-2103   EMC requirements
  Kia/Hyundai ES-95400-10
  Lotus 17.39.01   Lotus Engineering Standard: Electromagnetic Compatibility
  Mack Trucks 606GS15   EMC requirements
  MAN 3285   EMC requirements
  Mazda MES PW 67600   Automobile parts standard (electronic devices)
  Mercedes A 211 000 42 99   Instruction specification of test method for E/E-components
  Mercedes AV EMV   Electric aggregate and electronics in cars
  Mercedes MBN 10284-2   EMC requirements and tests of E/E-systems (component test procedures)
  Mercedes MBN 22100-2   Electric / electronic elements, devices in trucks
  Mitsubishi ES-X82010   General specification of environment tests on automotive electronic equipment
  Nissan 28400 NDS03   Low frequency surge resistance of electronic parts
  Nissan 28400 NDS07   Immunity against low frequency surge (induction surge) of electronic parts
  Nissan 28401 NDS02   EMC requirements (instruction concerning vehicle and electrical…)
  Porsche AV EMC EN   EMC requirements
  PSA B21 7090   EMC requirements (electric and electronics equipment)
  PSA B21 7110   EMC requirements (electric and electronics equipment)
  Renault 36.00.400   Physical environment of electrical and electronic equipments
  Renault 36.00.808   EMC requirements (cars and electrical / electronic components)
  Scania TB1400   EMC requirements
  Scania TB1700
  Smart DE10005B   EMC requirements (electric aggregate and electronics in cars)
  Toyota TSC7001G   Engineering standard (electric noise of electronic devices)
  Toyota TSC7001G-5.1   Power Supply Voltage Characteristic Test
  Toyota TSC7001G-5.2   Field Decay Test
  Toyota TSC7001G-5.3   Floating Ground Test
  Toyota TSC7001G-5.4   Induction Noise Resistance
  Toyota TSC7001G-5.5.3   Load Dump Test-1
  Toyota TSC7001G-5.5.4   Load Dump Test-2
  Toyota TSC7001G-5.5.5   Load Dump Test-3
  Toyota TSC7001G-5.6   Over Voltage Test
  Toyota TSC7001G-5.7.3   Ignition Pulse (Battery Waveforms) Test-1
  Toyota TSC7001G-5.7.4   Ignition Pulse (Battery Waveforms) Test-2
  Toyota TSC7001G-5.8   Reverse Voltage
  Toyota TSC7006G-4.4.2   Wide Band-Width Antenna Nearby Test (0.4 to 2 GHz)
  Toyota TSC7006G-4.4.3   Radio Equipment Antenna nearby Test (28 MHz …)
  Toyota TSC7006G-4.4.4   Mobile Phone Antenna Nearby Test (835 MHz…)
  Toyota TSC7018G   Static Electricity Test
  Toyota TSC7025G-5   TEM Cell Test (1 to 400 MHz)
  Toyota TSC7025G-6   Free Field Immunity Test (20 MHz to 1 GHz AM, 0.8 to 2 GHz PM)
  Toyota TSC7025G-7   Strip Line Test (20 – 400 MHz)
  Toyota TSC7026G-3.4   Narrow Band Emissions
  Toyota TSC7203G   Voltage Drop / Micro Drops
  Toyota TSC7508G-3.3.1   Conductive Noise in FM and TV Bands
  Toyota TSC7508G-3.3.2   Conductive noise in LW, AM and SW Bands
  Toyota TSC7508G-3.3.3   Radiated Noise in FM and TV Bands
  Toyota TSC7508G-3.3.4   Radiated Noise in AM, SW, and LW Bands
  Toyota TSC7203G   Engineering standard (ABS-TRC computers)
  Toyota TXC7315G   Electrostatic Discharge (Gap Method)
  Visteon ES-XU3F-1316-AA
  Volvo EMC Requirements   EMC requirements for 12V and 24V systems
  Volkswagen VW TL 801 01   Electric and electronic components in cars
  Volkswagen VW TL 820 66   Conducted Interference
  Volkswagen VW TL 821 66   EMC requirements of electronic components – bulk current injection (BCI)
  Volkswagen VW TL 823 66   Coupled Interference on Sensor Cables
  Volkswagen VW TL 824 66   Immunity Against Electrostatic Discharge
  Volkswagen VW TL 965   Short-Distance Interference Suppression

Related Posts:

Scroll to Top